Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR
  1. Clean and degrease the threads of the bolt for the camshaft position sensor.



    A158220
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



2. INSPECT FOR OIL LEAK


3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Fit the 3 retainers and install the No. 1 engine cover sub-assembly.