Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A259744
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. REMOVE CAMSHAFT POSITION SENSOR


    A259039
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.