Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

  1. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. If the crankshaft position sensor has been struck or dropped, replace it.
    2. Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.

  1. Connect the crankshaft position sensor connector.



2. INSPECT FOR OIL LEAK