Home › General › SPECIFICATIONS › 2AR-FXE ENGINE CONTROL

2AR-FXE ENGINE CONTROL > SERVICE DATA



Camshaft timing oil control valve assembly
Standard Resistance
20°C (68°F)
6.9 to 7.9 Ω
Throttle with motor body assembly
Standard Resistance
1 (M-) - 2 (M+)
0.3 to 100 Ω at 20°C (68°F)
Mass air flow meter sub-assembly
Standard Resistance
1 (THA) - 2 (E2)
13.6 to 18.4 kΩ at -20°C (-4°F)
1 (THA) - 2 (E2)
2.21 to 2.69 kΩ at 20°C (68°F)
1 (THA) - 2 (E2)
0.49 to 0.67 kΩ at 60°C (140°F)
Crankshaft position sensor
Standard Resistance
Cold
1630 to 2740 Ω
Hot
2065 to 3225 Ω
Spark plug
Standard Insulation Resistance
10 MΩor more
Recommended spark plug
FK16HR-A8 DENSO made
Maximum electrode gap
1.1 mm (0.0433 in.)
for used spark plug
Electrode gap
0.7 to 0.8 mm (0.0276 to 0.0315 in.)
for new spark plug
Engine coolant temperature sensor
Standard Resistance
20°C (68°F)
2.32 to 2.59 kΩ
80°C (176°F)
0.310 to 0.326 kΩ
Knock control sensor
Resistance
at 20°C (68°F)
120 to 280 kΩ
Air fuel ratio sensor
Standard Resistance
1 (HA1A) - 2 (+B)
1.6 to 3.2 Ω at 20°C (68°F)
1 (HA1A) - 4 (A1A-)
10 kΩ or higher
Oxygen sensor
Standard Resistance
1 (HT1B) - 2 (+B)
11 to 16 Ω at 20°C (68°F)
1 (HT1B) - 4 (E1)
10 kΩ or higher
EFI MAIN relay
Specified condition
No. 1 integration relay 1B-1 - No. 1 integration relay 1A-8
10 kΩ or higher
No. 1 integration relay 1B-1 - No. 1 integration relay 1A-8
Below 1 Ω (Battery voltage is applied between terminals 1C-7 and 1E-2)
No. 1 integration relay 1B-1 - No. 1 integration relay 1C-3
No. 1 integration relay 1B-1 - No. 1 integration relay 1C-4
No. 1 integration relay 1B-1 - No. 1 integration relay 1C-9
No. 1 integration relay 1B-1 - No. 1 integration relay 1C-10
EFI MAIN2 relay
Standard Resistance
No. 1 integration relay 1A-6 - No. 1 integration relay 1D-1
10 kΩ or higher
No. 1 integration relay 1A-6 - No. 1 integration relay 1D-1
Below 1 Ω (Battery voltage is applied between terminals 1A-8 and 1E-2)
No. 1 integration relay 1A-7 - No. 1 integration relay 1D-1
IG2 relay
Standard Resistance
No. 1 integration relay 1A-1 - No. 1 integration relay 1D-3
10 kΩ or higher
No. 1 integration relay 1A-1 - No. 1 integration relay 1D-3
Below 1 Ω (Battery voltage is applied between terminals 1C-8 and 1E-2)
No. 1 integration relay 1A-3 - No. 1 integration relay 1D-3
No. 1 integration relay 1C-1 - No. 1 integration relay 1D-3
No. 1 integration relay 1C-2 - No. 1 integration relay 1D-3
No. 1 integration relay 1C-5 - No. 1 integration relay 1D-3
C/OPN relay
Standard Resistance
No. 1 integration relay 1A-6 - No. 1 integration relay 1D-1
10 kΩ or higher
No. 1 integration relay 1A-6 - No. 1 integration relay 1D-1
Below 1 Ω (Battery voltage is applied between terminals 1A-1 and 1E-1)
No. 1 integration relay 1A-7 - No. 1 integration relay 1D-1