Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB

HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


4. REMOVE HEADLIGHT ASSEMBLY LH (for LH Side)
(Click here)


5. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH (for LH Side)


    E228329
  1. Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and disconnect it.

    NOTICE:
    1. Do not apply excessive force using a tool.
    2. Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.



    E228331
  1. Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and remove it.

    NOTICE:
    Do not pull the headlight light control ECU sub-assembly with the socket connected.



6. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH (for RH Side)

CAUTION:
The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.

  1. Disconnect the connector.



    E235329
  1. Turn the headlight light control ECU sub-assembly RH in the direction indicated by the arrow shown in the illustration, and disconnect it.

    NOTICE:
    1. Do not apply excessive force using a tool.
    2. Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.



    E235327
  1. Turn the socket of the headlight light control ECU sub-assembly RH in the direction indicated by the arrow shown in the illustration, and remove it.

    NOTICE:
    Do not pull the headlight light control ECU sub-assembly with the socket connected.



7. REMOVE DISCHARGE HEADLIGHT BULB


    E228333E01
  1. Release the set spring as shown in the illustration and remove the discharge headlight bulb.

    NOTICE:
    Do not touch the bulb glass.