Home › Engine / Hybrid System › 2AR-FXE COOLING › RADIATOR

RADIATOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK RADIATOR CAP SUB-ASSEMBLY


    A107446E01
  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.

    2. Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.

    3. Check that 3 and 4 are not stuck together.

    4. Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.

    5. When using the cap tester, tilt it upward 30° or more.



    6. A104601E09
    7. Pump the cap tester several times, and check the maximum pressure*1.
      Text in Illustration 
      *1
      Radiator Cap Tester
      *2
      Radiator Cap Sub-assembly
      *a
      30° or more

      Pumping speed:
      1 pump every second

      *1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

      Judgment Criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93.3 to 122.7 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18.0 psi)
      Minimum standard value
      (for used cap)
      78.5 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.