RADIATOR > REMOVAL |
| 1. PRECAUTION |
| 2. DRAIN COOLANT (for Engine) |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| 3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH |
| 5. REMOVE ENGINE UNDER COVER RH |
| 6. REMOVE ENGINE UNDER COVER LH |
| 7. REMOVE LUGGAGE TRIM SERVICE HOLE COVER |
![]() |
Disengage the claw to remove the luggage trim service hole cover.
| 8. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 9. REMOVE FRONT BUMPER ASSEMBLY |
| 10. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 11. REMOVE NO. 5 INVERTER BRACKET |
![]() |
Remove the 2 bolts and No. 5 inverter bracket.
| 12. REMOVE RADIATOR RESERVE TANK ASSEMBLY |
![]() |
Disconnect the radiator reserve tank hose.
Remove the 2 bolts and radiator reserve tank assembly.
| 13. DISCONNECT NO. 1 RADIATOR HOSE |
![]() |
Disconnect the No. 1 radiator hose.
| 14. DISCONNECT NO. 2 RADIATOR HOSE |
![]() |
Disconnect the No. 2 radiator hose and clamp.
| 15. DISCONNECT NO. 1 INVERTER COOLING PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the No. 1 inverter cooling pipe assembly.
| 16. REMOVE HOOD LOCK ASSEMBLY (for RHD) |
![]() |
Using a screwdriver, remove the hood lock nut cap.
| *1 | Protective Tape |
![]() |
Disconnect the connector.
![]() |
Remove the 2 bolts and hood lock bolt.
| *1 | Hood Lock Bolt |
![]() |
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
| 17. REMOVE HOOD LOCK ASSEMBLY (for LHD) |
![]() |
Using a screwdriver, remove the hood lock nut cap.
| *1 | Protective Tape |
![]() |
Disconnect the connector.
![]() |
Remove the 2 bolts and hood lock bolt.
| *1 | Hood Lock Bolt |
![]() |
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
| 18. REMOVE UPPER RADIATOR SUPPORT |
![]() |
Disconnect the 2 connectors.
![]() |
Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.
| *a | for RHD: |
| *b | for LHD: |
Remove the 2 radiator support cushions.
| 19. REMOVE RADIATOR ASSEMBLY |
![]() |
Disconnect the 2 clamps.
![]() |
Disconnect the 2 clamps and connector.
![]() |
Disconnect the clamp and No. 4 inverter cooling hose.
![]() |
Remove the 4 bolts and separate the condenser assembly from the radiator assembly (for inverter coolant).
![]() |
Remove the radiator assembly with the fan assembly.
Remove the 2 lower radiator supports.
![]() |
Release the 3 claws and lift the fan assembly from the radiator.