FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FOR FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAKS |
Check fuel pump operation.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG) and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the power switch off.
Disconnect the intelligent tester from the DLC3.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel system pressure (Click here).
Using a voltmeter, measure the auxiliary battery voltage.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the fuel hose from the fuel main tube (Click here).
![]() |
Install SST (pressure gauge) using other SST and a fuel tube connector as shown in the illustration.
| *1 | SST (Hose Band) |
| *2 | SST (T-joint) |
| *3 | SST (Pressure Gauge) |
| *4 | SST (Hose) |
| *5 | SST (Fuel Tube Connector) |
| *6 | Fuel Tube |
| *7 | Fuel Pipe |
Wipe up any spilled gasoline.
Connect the cable to the negative (-) auxiliary battery terminal.
Connect the intelligent tester to the DLC3.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Measure the fuel pressure.
Disconnect the intelligent tester from the DLC3.
Put the engine in inspection mode (Click here).
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine stops.
After checking the fuel pressure, disconnect the cable from the negative (-) auxiliary battery terminal and carefully remove SST to prevent gasoline from splashing.
Reconnect the fuel tube to the main fuel tube (fuel tube connector).
Install the No. 1 fuel pipe clamp to the fuel tube connector.
Inspect for fuel leaks (See step 1).
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.