ECO SWITCH > INSPECTION |
| 1. INSPECT ECO MODE SWITCH (ECO SWITCH ASSEMBLY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I49-6 (E) - I49-9 (ECU) | ECO mode switch (eco switch assembly) on | Below 1 Ω |
| I49-6 (E) - I49-9 (ECU) | ECO mode switch (eco switch assembly) off | 10 kΩ or higher |
| *a | Component without harness connected (ECO Mode Switch (Eco Switch Assembly)) |
Check that the switch illuminates.
Apply auxiliary battery voltage to the ECO mode switch (eco switch assembly) and check that the switch illuminates.
| Tester Connection | Specified Condition |
| Auxiliary battery positive (+) → Terminal 8 (ILL+) Auxiliary battery negative (-) → Terminal 7 (ILL-) | Illuminates |