Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B282096E21


Text in Illustration 
*A
for LHD
*B
for RHD
  1. Disconnect the MB and I12 main body ECU (multiplex network body ECU) connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connectors disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    MB-11(GND1) - Body ground
    -
    Ground
    Always
    Below 1 Ω
    I12-3 (GND2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    MB-30 (BECU) - Body ground
    -
    Auxiliary battery power supply
    Always
    11 to 14 V
    MB-29 (ACC) - Body ground
    -
    ACC power supply
    Power switch on (ACC)
    11 to 14 V
    MB-29 (ACC) - Body ground
    -
    ACC power supply
    Power switch off
    Below 1 V
    MB-31 (ALTB) - Body ground
    -
    Auxiliary battery power supply
    Always
    11 to 14 V
    MB-32 (IG) - Body ground
    -
    IG power supply
    Power switch on (IG)
    11 to 14 V
    MB-32 (IG) - Body ground
    -
    IG power supply
    Power switch off
    Below 1 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the MB and I12 main body ECU (multiplex network body ECU) connector.

  4. Measure the voltage and check for pulses according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3A-45 (GSW) - Body ground
    B - Body ground
    Airbag sensor signal (collision detection signal)
    Power switch on (IG) with airbag sensor assembly connector disconnected
    2.8 to 4.3 V
    3B-8 (ACT-) - Body ground
    V - Body ground*1
    GR - Body ground*2
    Door lock motor unlock drive output (except driver door)
    Door control switch (multiplex network master switch) or driver door key cylinder off
    Below 1 V
    3B-8 (ACT-) - Body ground
    V - Body ground*1
    GR - Body ground*2
    Door lock motor unlock drive output (except driver door)
    Door control switch (multiplex network master switch) or driver door key cylinder unlocked
    11 to 14 V
    3B-3 (ACT+) - Body ground
    W - Body ground
    Door lock motor lock drive output (all doors)
    Door control switch (multiplex network master switch) or driver door key cylinder off
    Below 1 V
    3B-3 (ACT+) - Body ground
    W - Body ground
    Door lock motor lock drive output (all doors)
    Door control switch (multiplex network master switch) or driver door key cylinder locked
    11 to 14 V
    3B-4 (ACTD) - Body ground
    GR - Body ground*1
    V - Body ground*2
    Driver door lock motor unlock drive output
    Door control switch (multiplex network master switch) or driver door key cylinder off
    Below 1 V
    3B-4 (ACTD) - Body ground
    GR - Body ground*1
    V - Body ground*2
    Driver door lock motor unlock drive output
    Door control switch (multiplex network master switch) or driver door key cylinder unlocked
    11 to 14 V
    I13-19 (FRCY) - Body ground
    Y - Body ground
    Front door courtesy light switch RH input
    Front door RH open
    Below 1 V
    I13-19 (FRCY) - Body ground
    Y - Body ground
    Front door courtesy light switch RH input
    Front door RH closed
    11 to 14 V
    3C-15 (FLCY) - Body ground
    L - Body ground
    Front door courtesy light switch LH input
    Front door LH open
    Below 1 V
    3C-15 (FLCY) - Body ground
    L - Body ground
    Front door courtesy light switch LH input
    Front door LH closed
    11 to 14 V
    I13-1 (LCTY) - Body ground
    P - Body ground
    Rear door courtesy light switch LH input
    Rear door LH open
    Below 1 V
    I13-1 (LCTY) - Body ground
    P - Body ground
    Rear door courtesy light switch LH input
    Rear door LH closed
    Pulse generation
    I13-6 (RCTY) - Body ground
    B - Body ground
    Rear door courtesy light switch RH input
    Rear door RH open
    Below 1 V
    I13-6 (RCTY) - Body ground
    B - Body ground
    Rear door courtesy light switch RH input
    Rear door RH closed
    Pulse generation
    I13-11 (L2) - Body ground
    R - Body ground
    Front door key-linked lock input
    Front door key cylinder turned to lock
    Below 1 V
    I13-11 (L2) - Body ground
    R - Body ground
    Front door key-linked lock input
    Front door key cylinder off
    Pulse generation
    I13-24 (UL3) - Body ground
    GR - Body ground*1
    Y - Body ground*2
    Driver door key-linked unlock input
    Driver door key cylinder turned to unlock
    Below 1 V
    I13-24 (UL3) - Body ground
    GR - Body ground*1
    Y - Body ground*2
    Driver door key-linked unlock input
    Driver door key cylinder off
    Pulse generation
    I13-7 (LSFL) - Body ground
    V - Body ground
    Front door LH unlock detection switch input
    Front door LH unlocked
    Below 1 V
    I13-7 (LSFL) - Body ground
    V - Body ground
    Front door LH unlock detection switch input
    Power switch off, all doors closed and front door LH locked
    Pulse generation
    I13-18 (LSFR) - Body ground
    W - Body ground
    Front door RH unlock detection switch input
    Front door RH unlocked
    Below 1 V
    I13-18 (LSFR) - Body ground
    W - Body ground
    Front door RH unlock detection switch input
    Power switch off, all doors closed and front door RH locked
    Pulse generation
    3A-53 (LSR) - Body ground
    Y - Body ground
    Rear door RH unlock detection switch input
    Rear door RH or LH unlocked
    Below 1 V
    3A-53 (LSR) - Body ground
    Y - Body ground
    Rear door RH unlock detection switch input
    Power switch off, all doors closed, rear door RH and LH locked
    Pulse generation
    3C-17 (LSR) - Body ground
    LG - Body ground
    Rear door LH unlock detection switch input
    Rear door LH or RH unlocked
    Below 1 V
    3C-17 (LSR) - Body ground
    LG - Body ground
    Rear door LH unlock detection switch input
    Power switch off, all doors closed, rear door LH and RH locked
    Pulse generation
    3C-9 (LGCY) - Body ground
    W - Body ground
    Luggage compartment door courtesy light switch input
    Luggage compartment door open
    Below 1 V
    3C-9 (LGCY) - Body ground
    W - Body ground
    Luggage compartment door courtesy light switch input
    Luggage compartment door closed
    11 to 14 V

    1. *1: for LHD
    2. *2: for RHD
    If the result is not as specified, the main body ECU (multiplex network body ECU) or instrument panel junction block assembly may have a malfunction.