Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
  1. Connect the connector.

  1. Install the No. 1 indoor electrical key antenna assembly with the bolt.

    NOTICE:
    Be careful when installing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

  1. Engage the clamp.



2. INSTALL NO. 4 CONSOLE BOX DUCT
  1. Engage the claw to install the No. 4 console box duct.



3. INSTALL UPPER CONSOLE BOX SUB-ASSEMBLY
  1. Connect the 2 connectors.

  1. Engage the clamp.



    B277990
  1. Engage the 2 guides and 4 clips as shown in the illustration.

  1. Install the upper console box sub-assembly with the 2 screws.



4. INSTALL REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Connect each connector.



    B280334
  1. Engage the 6 clips to install the rear console upper panel sub-assembly.

  1. Move the shift lever to P.



5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B281912
  1. Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.



6. INSTALL FRONT PANEL GARNISH RH


    B280333
  1. Engage the 3 clips and 8 guides to install the front panel garnish RH.



7. INSTALL FRONT PANEL GARNISH LH


    B281945
  1. Engage the 3 clips and 8 guides to install the front panel garnish LH.