Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > REMOVAL

for Preparation Click here



1. REMOVE FRONT PANEL GARNISH LH


    B280331
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



2. REMOVE FRONT PANEL GARNISH RH


    B280332
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH as shown in the illustration.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B281911
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



  1. Disengage the 6 clips as shown in the illustration.


    B280335

  1. Disconnect each connector to remove the rear console upper panel sub-assembly.



5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY


    B278005
  1. Remove the 2 screws.



    B277989
  1. Disengage the 4 clips and 2 guides as shown in the illustration.



    B280337
  1. Disengage the clamp.

  1. Disconnect the 2 connectors to remove the upper console box sub-assembly.



6. REMOVE NO. 4 CONSOLE BOX DUCT


    B293623
  1. Disengage the claw and remove the No. 4 console box duct.



7. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279162
  1. Disengage the clamp.

  1. Remove the bolt.

  1. Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.