LIGHTING SYSTEM > Taillight Relay Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Taillight Relay | Taillight relay | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
![]() |
Disconnect the 3E*1 or 3F*2 instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3E-1*1 - Body ground | Always | 11 to 14 V |
| 3F-1*2 - Body ground | Always | 11 to 14 V |
| *A | for LHD |
| *B | for RHD |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

Connect a positive (+) lead from the auxiliary battery to terminal 3E-1*1 or 3F-1*2.
Connect a negative (-) lead from the auxiliary battery to terminal MB-14.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3D-7 - Auxiliary battery negative | Always | 11 to 14 V |
| 3D-8 - Auxiliary battery negative | Always | 11 to 14 V |
| 3C-5 - Auxiliary battery negative | Always | 11 to 14 V |
| *A | for LHD | *B | for RHD |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
|
| ||||
| OK | ||
| ||