Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect each connector.

  1. Engage each clamp.

  1. Install the headlight assembly with the 3 screws and bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


4. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
  1. Engage the claw to connect the luggage trim service hole cover.



5. ADJUST HEADLIGHT AIMING
(Click here)


6. ADJUST FOG LIGHT AIMING
(Click here)