HEADLIGHT ASSEMBLY > DISASSEMBLY |
| 1. REMOVE HEADLIGHT COVER |
![]() |
Remove the 3 screws.
![]() |
Disengage the 2 claws and 8 guides to remove the headlight cover
| 2. REMOVE NO. 1 HEADLIGHT BULB |
![]() |
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.
| 3. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY |
![]() |
Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and disconnect it.
![]() |
Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and remove it.
| 4. REMOVE DISCHARGE HEADLIGHT BULB |
![]() |
Release the set spring as shown in the illustration and remove the discharge headlight bulb.
| 5. REMOVE HEADLIGHT SOCKET COVER |
Remove the headlight socket cover from the headlight unit.
| 6. REMOVE FRONT TURN SIGNAL LIGHT BULB |
![]() |
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
| 7. REMOVE HEADLIGHT LEVELING MOTOR |
![]() |
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration.
| *a | Aiming Screw |
Turn the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to disengage the pin.
![]() |
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (3) shown in the illustration to disengage the shaft.
| *a | Aiming Screw |
Pull out the headlight leveling motor in the direction indicated by the arrow (4) shown in the illustration to remove it.
| 8. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING |
Remove the headlight leveling motor base packing.
| 9. REMOVE GROMMET |
![]() |
Using needle-nosed pliers, remove the grommet.