Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD

RADIO ANTENNA CORD > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)


2. REMOVE NO. 3 HEATER TO REGISTER DUCT (for LHD)


    B281907
  1. Remove the clip.

  1. Remove the 3 screws <C> and No. 3 heater to register duct.



3. REMOVE HEATER TO REGISTER DUCT ASSEMBLY (for RHD)


    B281904
  1. Remove the clip.

  1. Remove the 3 screws <C>.

  1. Disengage the heater to register duct assembly from the ion generator assembly, to remove the heater to register duct.



4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B281908
  1. Remove the screw <C>.

  1. Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.



5. REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)


  1. Disengage the 8 clamps and remove the antenna cord sub-assembly.


    E226780



6. REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)


  1. Disengage the 10 clamps and remove the antenna cord sub-assembly.


    E227950



7. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



  1. Remove the No. 2 antenna cord sub-assembly from the roof headlining.


    E227938E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *1
    Tape
    -
    -
    *a
    Front
    -
    -