Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the power switch on (READY), check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E226091E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    300.0 mm (11.8 in.)
    B
    145.0 mm (5.71 in.)
    C
    170.0 mm (6.69 in.)
    -
    -

    Text in Illustration 
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    -
    -

    HINT:
    If the result is not as specified, replace the washer nozzle sub-assembly.