FRONT WIPER MOTOR > INSTALLATION |
| 1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY |
Using a T30 "TORX" socket wrench, install the windshield wiper motor assembly with 2 bolts.
Connect the connector.
Turn the power switch on (IG).
Operate the wiper and stop the windshield wiper motor assembly at the automatic stop position.
Turn the power switch off.
Disconnect the connector.
![]() |
Apply MP grease to the pivot of the windshield wiper motor assembly.
| *a | Pivot of the windshield wiper motor assembly |
![]() |
Connect the No. 1 rod to the pivot of the windshield wiper motor assembly.
| *a | Pivot of the windshield wiper motor assembly |
| *1 | No. 1 Rod |
| 2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD) |
![]() |
Engage the motor grommet as shown in the illustration.
| *1 | Motor Grommet |
Install the windshield wiper motor and link assembly with the 2 bolts.
Connect the connector.
| 3. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD) |
![]() |
Engage the motor grommet as shown in the illustration.
| *1 | Motor Grommet |
Install the windshield wiper motor and link assembly with the 2 bolts.
Connect the connector and then engage the 2 clamps.
| 4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
Engage the 8 guides as shown in the illustration.

Engage the 6 claws and guide to install the cowl top ventilator louver sub-assembly.

| 5. INSTALL FRONT FENDER TO COWL SIDE SEAL LH |
![]() |
Engage the 3 guides and 2 clips to install the front fender to cowl side seal LH as shown in the illustration.
| 6. INSTALL FRONT FENDER TO COWL SIDE SEAL RH |
| 7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH |
![]() |
When reusing the front wiper arm and blade assembly LH:
Clean the wiper arm serrations.
| *a | Wiper Arm Serration |
![]() |
When reusing the windshield wiper link assembly:
Clean the wiper pivot serrations with a wire brush.
| *a | Wiper Pivot Serration |
![]() |
Set the front wiper arm and blade assembly LH in the range shown in the illustration and then install the front wiper arm and blade assembly LH with the nut.
| Area | Measurement |
| A | 7.5 mm (0.295 in.) |
| *1 | Ceramic Dot |
| 8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH |
![]() |
When reusing the front wiper arm and blade assembly RH:
Clean the wiper arm serrations.
| *a | Wiper Arm Serration |
![]() |
When reusing the windshield wiper link assembly:
Clean the wiper pivot serrations with a wire brush.
| *a | Wiper Pivot Serration |
![]() |
Set the front wiper arm and blade assembly RH in the range shown in the illustration and then install the front wiper arm and blade assembly RH with the nut.
| Area | Measurement |
| A | 7.5 mm (0.295 in.) |
| *1 | Ceramic Dot |
Turn the power switch on (IG).
Operate the front wiper while spraying washer fluid onto the windshield glass. Make sure that the front wiper functions properly and the wiper does not come into contact with the vehicle body.
Lift each wiper arm twice after the wipers stop and check the wiper set position.
Turn the power switch off.