WASHER LEVEL WARNING SWITCH > INSPECTION |
| 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY |
Fill the washer jar with washer fluid.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (S) - 2 (E) | Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher * | 10 kΩ or higher |
| Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower * | Below 1 Ω |
| *a | Component without harness connected (Level Warning Switch Assembly) |