Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


    E226631
  1. Remove the 3 screws and front wheel opening extension pad RH.



3. REMOVE FRONT FENDER LINER RH


    E231344
  1. Remove the clip.



    E226453E01
  1. Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.
    Text in Illustration 
    *a
    90°



    E226455E01
  1. Remove the 5 screws.
    Text in Illustration 
    *1
    Grommet

  1. Remove the 4 clips, 2 grommets and front fender liner RH.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



4. DRAIN WASHER FLUID


    E228031
  1. Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



5. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    E226462
  1. Disconnect the connector.

  1. Remove the level warning switch assembly as shown in the illustration.