BLACK OUT TAPE (for Front Door) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER |
![]() |
Disengage the claw to remove the luggage trim service hole cover.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
| 5. REMOVE FRONT DOOR SERVICE HOLE COVER |
![]() |
Disconnect each connector.
Disengage the 4 clamps.
Remove the front door service hole cover.
| 6. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the grommet.
Connect the cable to the negative (-) auxiliary battery terminal.
Connect the multiplex network master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the multiplex network master switch assembly.
![]() |
Remove the 2 bolts.
![]() |
Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.
| 7. REMOVE FRONT DOOR GLASS RUN |
![]() |
Remove the front door glass run.
| 8. REMOVE FRONT DOOR CHECK ASSEMBLY |
![]() |
Remove the 3 bolts and front door check assembly.
| 9. REMOVE FRONT DOOR WEATHERSTRIP |
![]() |
Using a clip remover, disengage the 19 clips and remove the front door weatherstrip.
| 10. REMOVE DOOR FRAME GARNISH |
![]() |
Disengage the clip and remove the door frame garnish.
| 11. REMOVE FRONT DOOR STRIPE |
Using a heat light, heat the front door stripe and vehicle body.
| Item | Temperature |
| Vehicle Body and Front Door Outside Stripe | 40 to 60°C (104 to 140°F) |
![]() |
Pull back on one of the ends of the front door stripe to remove it.
| 12. REMOVE FRONT DOOR LOWER OUTSIDE STRIPE |
Using a heat light, heat the front door lower outside stripe and vehicle body.
| Item | Temperature |
| Vehicle Body and Front Door Rear Outside Stripe | 40 to 60°C (104 to 140°F) |
![]() |
Pull back on one of the ends of the front door lower outside stripe to remove it.