Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING

REAR DOOR WINDOW FRAME MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL REAR DOOR UPPER WINDOW FRAME MOULDING


    B280097
  1. Engage the guide of the rear door upper window frame moulding to the door frame.

  1. Using an air riveter or hand riveter with a nose piece, install the rear door upper window frame moulding with 6 new rivets.

    HINT:
    If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

    NOTICE:

    1. B125583E09
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
      Text in Illustration 
      *1
      Riveter
      *2
      Mandrel
      *a
      Incorrect

    2. B125584E10
      Confirm that the rivets are seated properly against the moulding. Do not tilt the riveter when installing the rivet to the moulding. Do not leave any space between the rivet head and moulding.
      Text in Illustration 
      *1
      Riveter
      *a
      Incorrect

    3. B125585E12
      Do not leave any space between the moulding and door frame. Firmly hold the 2 items together while installing the rivet.
      Text in Illustration 
      *1
      Riveter
      *a
      Incorrect



2. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING

HINT:
When installing a new rear door front window frame moulding, heat the vehicle body and rear door front window frame moulding using a heat light.

Heating Temperature 
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or rear door front window frame moulding excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.



    B280094E01
  1. Install a new rear door front window frame moulding.
    Text in Illustration 
    *1
    Double-sided Tape
    *2
    Caulking Sponge

    1. Using a heat light, heat the vehicle body and rear door front window frame moulding.

    2. Remove the release paper from the rear door front window frame moulding.

      HINT:
      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. Install the rear door front window frame moulding with the clip.



3. INSTALL REAR DOOR BELT MOULDING ASSEMBLY
(Click here)