THEFT DETERRENT SYSTEM > Horn Circuit |

| 1.INSPECT HORNS |
Press the horn switch and check if the horns sound.
| Result | Proceed to |
| Horns sound | A |
| Horns do not sound | B |
|
| ||||
| A | |
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the main body ECU (multiplex network body ECU) (Click here).

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3D-15 - MB-28 (HORN) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||