Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER

INSTRUMENT PANEL SPEAKER > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B298720
  1. Disconnect the front door opening trim weatherstrip LH.



2. REMOVE FRONT PILLAR GARNISH


    B278985E01
  1. Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the 2 clips.
    Text in Illustration 
    *1
    Front Pillar Garnish Clip

    HINT:
    Make the front pillar garnish LH hang down from the front pillar garnish clip.



    B278986E01
  1. While pushing the tabs on the front pillar garnish clip in the direction indicated by the arrow (A) shown in the illustration, disengage the front pillar garnish clip.

  1. Pull the garnish in the direction indicated by the arrow (B) shown in the illustration to disengage the 2 guides and remove the front pillar garnish LH.



    B278988E01
  1. Protect the curtain shield airbag assembly.
    Text in Illustration 
    *1
    Adhesive Tape
    *2
    Protective Cover
    *3
    Curtain Shield Airbag Assembly

    1. Cover the airbag with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.



3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B280301E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B280302
  1. Using a moulding remover, disengage the 2 clips and 3 claws.

  1. Disengage the 2 guides to remove the No. 1 instrument panel speaker panel sub-assembly.



4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    E231530
  1. Remove the 2 screws.



    E226777
  1. Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.

    NOTICE:
    Do not touch the speaker cone.