IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. PERFORM SPARK TEST |
Check for DTCs (Click here).
Remove the ignition coil assemblies and spark plugs (Click here).
![]() |
Disconnect the 4 injector connectors.
Install the spark plug into the ignition coil assembly, and then connect the ignition coil connector.
![]() |
Ground the spark plug.
Check that spark occurs at each spark plug while the engine is being cranked.
![]() |
Connect the 4 fuel injector connectors.
Install the spark plugs and ignition coil assemblies (Click here).
Check for DTCs (Click here).
Clear the DTCs (Click here).
| 2. INSPECT IGNITION COIL AND SPARK TEST |
Check that the wire harness side connector of the ignition coil assembly is securely connected.
| Result | Action |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil assembly.
Replace the ignition coil assembly with a known good one.
Perform the spark test again.
| Result | Action |
| NG | Go to next step |
| OK | Replace ignition coil assembly |
Perform a spark test on each spark plug.
Replace the spark plug with a known good one.
Perform the spark test again.
| Result | Action |
| NG | Inspect the ignition system (Click here). |
| OK | Replace spark plug |
| 3. CHECK SPARK PLUG |
![]() |
Check the electrode using a megohmmeter:
| *a | Ground |
Using a megohmmeter, measure the insulation resistance.
| Tester Connection | Condition | Specified Condition |
| Spark plug (terminal part) - Body ground | Always | 10 MΩ or higher |
![]() |
Alternative inspection method:
Quickly accelerate the engine to 4000 rpm 5 times.
Remove the spark plug (Click here).
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its thread and insulator.
If there is any damage, replace the spark plug.
| Manufacturer | Spark Plug Type |
| DENSO | FK16HR-A8 |
Reference:
![]() |
Check the spark plug electrode gap.
| *1 | Iridium chip |
| *2 | Platinum chip |
| *a | Spark plug electrode gap |
![]() |
Clean the spark plugs.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.
Install the spark plug (Click here).