Home › Engine / Hybrid System › 2AR-FXE EMISSION CONTROL › PURGE VALVE

PURGE VALVE > REMOVAL

for Preparation Click here



1. REMOVE PURGE VSV


    A258713
  1. Disconnect the connector.



    A259684E01
  1. Disconnect the 2 fuel vapor feed hoses.
    Text in Illustration 
    *1
    Retainer
    *2
    Fuel Tube Connector
    *3
    Pipe
    *4
    O-ring
    *a
    Pull

    NOTICE:
    1. Remove any dirt or foreign matter on the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel vapor feed hose.

  1. Remove the purge VSV from the No. 1 air cleaner hose.



    A258715
  1. Disconnect the connector and 2 wire harness clamps to remove the engine wire.

  1. Remove the fuel vapor feed hose from the purge VSV.