Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > INSPECTION

for Preparation Click here



1. INSPECT TIE ROD ASSEMBLY


    C132329
  1. Secure the tie rod assembly in a vise.

    NOTICE:
    Do not overtighten the vise.

  1. Install the nut to the stud bolt.

  1. Flip the ball joint back and forth 5 times.

  1. Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

    Standard turning torque:
    1.0 to 4.0 N*m (10 to 40 kgf*cm, 9 to 35 in.*lbf)

    HINT:
    If the turning torque is not within the specified range, replace the tie rod assembly.



2. INSPECT TOTAL PRELOAD

NOTICE:
Inspect the total preload in a no-load condition by removing the tie rod assembly RH and LH, and steering rack boots.



    C239563E01
  1. Install SST to the pinion shaft and turn it left and right 5 times or more.

    SST
    09616-00020  

  1. Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

    Standard preload:
    0.7 to 1.1 N*m (7 to 11 kgf*cm, 6 to 9 in.*lbf)

    NOTICE:
    Inspect the total preload around the steering rack center position.

    HINT:
    If the total preload is not within the specified range, replace the steering gear assembly with a new one.