Home › Drivetrain › P314 HYBRID TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > ADJUSTMENT

for Preparation Click here



1. INSPECT SHIFT LEVER POSITION
  1. While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.

  1. Put the vehicle into the READY-on state and check the following:

    1. When the shift lever is moved to D, the vehicle moves forward.

    2. When the shift lever is moved to R, the vehicle moves in reverse.

      NOTICE:
      The vehicle should not move when the shift position indicator is off.



2. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.

  1. Remove the console box (Click here).



    C348791
  1. Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

  1. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.



    C194520E08
  1. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.
    Text in Illustration 
    *a
    Slider
    *b
    Lock Piece
    *c
    Slide
    *d
    Pull

  1. Engage the 2 claws to connect the transmission control cable assembly to the lower shift lever assembly.



    C348795E01
  1. Connect the end of the transmission control cable assembly to the lower shift lever assembly.
    Text in Illustration 
    *a
    Lock Piece

    NOTICE:
    1. Check that the lock piece is pulled up.
    2. Install the cable end all the way to the base of the pin.

  1. Push the lock piece into the adjuster case.

    NOTICE:
    1. Check that the shift lever position sensor and the shift lever are in neutral.
    2. Securely push in the lock piece until the slider lock is engaged.

  1. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

  1. Install the console box (Click here).