Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > TERMINALS OF ECU

for Preparation Click here



TERMINAL INSPECTION

B118684E72


Text in Illustration 
*a
Component without harness connected
(Steering Lock ECU (Steering Lock Actuator Assembly))
-
-


  1. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Input/Output
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Related Data List Item
    I24-1 (GND) - Body ground
    -
    W-B - Body ground
    Ground*
    Always
    Below 1 Ω
    -
    I24-3 (IGE) - I24-1 (GND)
    Input
    SB - W-B
    Steering lock motor activation command signal (motor activation command signal sent from certification ECU (smart key ECU assembly))
    Any door opened when conditions below met, and then steering lock motor activated:
    1. Shift lever in P
    2. Steering lock unlocked in advance by carrying key and turning power switch on (IG)
    3. After above conditions met, power switch turned off
    Pulse generation (see waveform)
    Entry&Start
    1. Power Supply Short
    2. Unlock Request Receive
    3. Lock Request Receive
    I24-4 (SLP1) - I24-1 (GND)
    Output
    P - W-B
    Steering lock bar position signal (output signal from steering unlock sensor)
    Steering locked → unlocked
    11 to 14 V → Below 1.2 V
    Entry&Start
    1. Push Start Error
    2. Sensor Value
    I24-5 (LIN) - I24-1 (GND)
    Input/Output
    Y - W-B
    LIN communication line
    -
    -
    Entry&Start
    1. Steering Lock Start Cond
    I24-6 (IG2) - I24-1 (GND)
    Input
    LG - W-B
    Power source mode signal (IG2 power supply input for entire steering lock actuator assembly)*
    Power switch off → power switch on (IG)
    Below 1 V → 11 to 14 V
    Entry&Start
    1. Ignition Switch
    I24-7 (B) - Body ground
    Input
    B - Body ground
    Power source*
    Always
    11 to 14 V
    -

    1. *: When there is a problem with the power source input, the certification ECU (smart key ECU assembly) may store DTC B2786.

    NOTICE:
    There are 1 motor and 2 sensors built into the steering lock actuator assembly.

    HINT:
    1. When taking measurements when the lock motor is stopped, it is not necessary to perform any operations.
    2. In order to take measurements when the lock motor is operating, perform either of the following operations:
      1. To unlock the steering, carry the key and turn the power switch on (ACC) or on (IG) with the shift lever in P.
      2. To lock the steering, turn the power switch off with the shift lever in P, and then open a door.




      C221561E01
    1. Waveform
      Item
      Content
      Tester Connection
      I24-3 (IGE) - I24-1 (GND)
      Tool Setting
      2 V/DIV., 200 ms./DIV.
      Vehicle Condition
      Steering lock motor not operating → Steering lock motor operating → Steering lock motor not operating
      Text in Illustration 
      *a
      Steering lock motor not operating
      *b
      Steering lock motor operating