Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Inside Handle Illumination Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network ECU) controls the inside handle illumination lights.

WIRING DIAGRAM


E227047E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. Check that the inside handle illumination lights come on.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Inside Handle Illumination
    Inside handle illumination lights
    ON/OFF
    Power switch is turned off just before performing the Active Test.

    OK:
    Inside handle illumination lights come on.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INSIDE HANDLE ILLUMINATION LIGHT ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Disconnect the I12 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the K8 front door inside handle illumination light assembly LH connector.

  1. Disconnect the J8 front door inside handle illumination light assembly RH connector.

  1. Disconnect the M3 rear door inside handle illumination light assembly LH connector.

  1. Disconnect the L3 rear door inside handle illumination light assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I12-4 (OSPT) - K8-1
    Always
    Below 1 Ω
    I12-4 (OSPT) - J8-1
    Always
    Below 1 Ω
    I12-4 (OSPT) - M3-1
    Always
    Below 1 Ω
    I12-4 (OSPT) - L3-1
    Always
    Below 1 Ω
    I12-4 (OSPT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)