Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM > Headlight Beam Level Warning Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU assembly sends a warning display signal to the combination meter assembly if it detects a malfunction in the headlight beam level control system. When the combination meter assembly receives the warning display signal, it alerts the driver by displaying "Check Headlight Leveling System" on the multi-information display.

WIRING DIAGRAM


E303355E03


INSPECTION PROCEDURE

1.CHECK HEADLIGHT LEVELING ECU ASSEMBLY (INPUT SIGNAL)


    E223776E04
  1. Disconnect the A34 headlight leveling ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A34-6 (WNG) - Body ground
    Power switch on (IG)
    11 to 14 V
    Power switch off
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Leveling ECU Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the I17 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A34-6 (WNG) - I17-11 (LVWG)
    Always
    Below 1 Ω
    A34-6 (WNG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO METER / GAUGE SYSTEM (Click here)