REPAIR INSTRUCTION > INSPECTION MODE PROCEDURE |
| INSPECTION MODE |
The following table shows the types of inspection modes that are available, their purpose and the control that occurs in each mode.
| Mode (Display) | Purpose | Control |
| MAINTENANCE MODE (2WD for measuring Exhaust Gas) |
|
|
| CERTIFICATION MODE (2WD for cutting TRC) | Tests using a speedometer tester, two-wheel chassis dynamometer, etc. | Cancels traction control |
Vehicle conditions
Before activating inspection mode, turn the air conditioning off, start the hybrid system with the shift lever in P, and check that the engine stops within several seconds after starting (engine warm up check).
Activate the appropriate inspection mode and inspect the vehicle:
| Test Item | Mode |
| 1. Vehicle straight travelling test (side slip inspection) | Maintenance mode or normal mode |
| 2. Braking force test | Normal mode |
| 3. Speedometer test | Maintenance mode |
| 4. Exhaust gas test (idling) | Maintenance mode |
| 5. Headlight test | Maintenance mode or normal mode |
Cancel inspection mode immediately after completion of inspection.
Special notes for speedometer test
Depress the accelerator pedal slowly and gradually accelerate the vehicle. Make a measurement.
After the measurement, use the brakes to gradually decelerate the vehicle.
Special notes for using a chassis dynamometer
Always set an appropriate load before starting the test.
Activating maintenance mode (Not using the intelligent tester)
Perform the following steps from (A) through (D) in 60 seconds.
![]() |
Check that "MAINTENANCE MODE" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating maintenance mode (Using the intelligent tester)
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter following menus: Powertrain / Hybrid Control / Utility / Inspection Mode - 2WD for measuring Exhaust Gas.
![]() |
Check that "MAINTENANCE MODE" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating certification mode (Not using the intelligent tester)
Perform the following steps from (A) through (D) in 60 seconds.
![]() |
Check that "CERTIFICATION MODE" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Activating certification mode (Using the intelligent tester)
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter following menus: Powertrain / Hybrid Control / Utility / Inspection Mode - 2WD for cutting TRC.
![]() |
Check that "CERTIFICATION MODE" is displayed on the multi-information display.
Start the engine by turning the power switch on (READY) while depressing the brake pedal.
Deactivating inspection mode
Turn the power switch off. The hybrid system turns off simultaneously.