WIPER AND WASHER SYSTEM > Wiper and Washer Switch Circuit |
| for LHD |

| for RHD |

| 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
for LHD:
Remove the windshield wiper switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I32-3 (+1) - I32-1 (+S) | OFF | Below 1 Ω |
| I32-3 (+1) - I32-2 (+B) | MIST | |
| LO | ||
| I32-2 (+B) - I32-4 (+2) | HI | |
| I32-8 (AUTO) - I32-9 (E) | AUTO |
| Tester Connection | Switch Condition | Specified Condition |
| I31-4 (EW) - I31-7 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| I32-7 (VR1) - I32-6 (VR2) | P1 | 209 to 231 Ω |
| P2 | 114 to 126 Ω | |
| P3 | 58.9 to 65.1 Ω | |
| P4 | Below 1 Ω |
| *1 | Windshield Wiper Switch Assembly (Adjusting Ring Position) |
| *a | Component without harness connected (Windshield Wiper Switch Assembly) |
![]() |
for RHD:
Remove the windshield wiper switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I32-2 (+1) - I32-4 (+S) | OFF | Below 1 Ω |
| I32-2 (+1) - I32-3 (+B) | MIST | |
| LO | ||
| I32-3 (+B) - I32-1 (+2) | HI | |
| I32-7 (AUTO) - I32-6 (E) | AUTO |
| Tester Connection | Switch Condition | Specified Condition |
| I31-7 (EW) - I31-4 (WF) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| I32-9 (VR1) - I32-8 (VR2) | P1 | 209 to 231 Ω |
| P2 | 114 to 126 Ω | |
| P3 | 58.9 to 65.1 Ω | |
| P4 | Below 1 Ω |
| *1 | Windshield Wiper Switch Assembly (Adjusting Ring Position) |
| *a | Component without harness connected (Windshield Wiper Switch Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - WINDSHIELD WIPER RELAY ASSEMBLY AND BODY GROUND) |
for LHD:
Disconnect the I72 windshield wiper relay assembly connector and B1 windshield wiper motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I32-2 (+B) - I72-2 (IG) | Always | Below 1 Ω |
| I32-2 (+B) - Body ground | Always | 10 kΩ or higher |
| I32-3 (+1) - B1-5 (+1) | Always | Below 1 Ω |
| I32-3 (+1) - Body ground | Always | 10 kΩ or higher |
| I32-4 (+2) - I72-11 (+2) | Always | Below 1 Ω |
| I32-4 (+2) - B1-3 (+2) | Always | Below 1 Ω |
| I32-4 (+2) - Body ground | Always | 10 kΩ or higher |
| I32-1 (+S) - I72-10 (+1) | Always | Below 1 Ω |
| I32-1 (+S) - Body ground | Always | 10 kΩ or higher |
| I32-8 (AUTO) - I72-3 (C1) | Always | Below 1 Ω |
| I32-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| I32-9 (E) - I72-5 (CO) | Always | Below 1 Ω |
| I32-9 (E) - Body ground | Always | 10 kΩ or higher |
| I32-7 (VR1) - I72-21 (VR1) | Always | Below 1 Ω |
| I32-7 (VR1) - Body ground | Always | 10 kΩ or higher |
| I32-6 (VR2) - I72-8 (VR2) | Always | Below 1 Ω |
| I32-6 (VR2) - Body ground | Always | 10 kΩ or higher |
| I31-7 (WF) - I72-25 (W) | Always | Below 1 Ω |
| I31-7 (WF) - Body ground | Always | 10 kΩ or higher |
| I31-4 (EW) - Body ground | Always | Below 1 Ω |
for RHD:
Disconnect the I72 windshield wiper relay assembly connector and B1 windshield wiper motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I32-3 (+B) - I72-2 (IG) | Always | Below 1 Ω |
| I32-3 (+B) - Body ground | Always | 10 kΩ or higher |
| I32-2 (+1) - B1-1 (+1) | Always | Below 1 Ω |
| I32-2 (+1) - Body ground | Always | 10 kΩ or higher |
| I32-1 (+2) - I72-11 (+2) | Always | Below 1 Ω |
| I32-1 (+2) - B1-4 (+2) | Always | Below 1 Ω |
| I32-1 (+2) - Body ground | Always | 10 kΩ or higher |
| I32-4 (+S) - I72-10 (+1) | Always | Below 1 Ω |
| I32-4 (+S) - Body ground | Always | 10 kΩ or higher |
| I32-7 (AUTO) - I72-3 (C1) | Always | Below 1 Ω |
| I32-7 (AUTO) - Body ground | Always | 10 kΩ or higher |
| I32-6 (E) - I72-5 (CO) | Always | Below 1 Ω |
| I32-6 (E) - Body ground | Always | 10 kΩ or higher |
| I32-9 (VR1) - I72-21 (VR1) | Always | Below 1 Ω |
| I32-9 (VR1) - Body ground | Always | 10 kΩ or higher |
| I32-8 (VR2) - I72-8 (VR2) | Always | Below 1 Ω |
| I32-8 (VR2) - Body ground | Always | 10 kΩ or higher |
| I31-4 (WF) - I72-25 (W) | Always | Below 1 Ω |
| I31-4 (WF) - Body ground | Always | 10 kΩ or higher |
| I31-7 (EW) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||