REAR VIEW MONITOR SYSTEM > Image from Camera for Rear View Monitor is Abnormal |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY) |
Disconnect the I154 connector from the radio and display receiver assembly.
Disconnect the T6 connector from the rear television camera assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I154-8 (V+) - T6-3 (CV+) | Always | Below 1 Ω |
| I154-7 (CA+) - T6-6 (CB+) | Always | Below 1 Ω |
| I154-15 (CGND) - T6-5 (CGND) | Always | Below 1 Ω |
| I154-16 (V-) - T6-2 (CV-) | Always | Below 1 Ω |
| I154-8 (V+) - Body ground | Always | 10 kΩ or higher |
| I154-7 (CA+) - Body ground | Always | 10 kΩ or higher |
| I154-16 (V-) - Body ground | Always | 10 kΩ or higher |
| I154-15 (CGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY |
![]() |
Reconnect the I154 connector to the radio and display receiver assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I154-16 (V-) - Body ground | Always | Below 1 Ω |
| I154-15 (CGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I154-7 (CA+) - I154-15 (CGND) | Power switch on (IG) Shift lever in R | 5.5 to 7.05 V |
| *a | Component with harness connected (Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 3.INSPECT REAR TELEVISION CAMERA ASSEMBLY |
Reconnect the T6 connector to the rear television camera assembly.
![]() |
Check the waveform of the rear television camera assembly using an oscilloscope.
| Item | Content |
| Terminal No. (Symbol) | I154-8 (V+) - I152-7 (GND1) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Power switch on (IG), shift lever in R |
| *a | Component with harness connected (Radio and Display Receiver Assembly) |
| *b | Waveform 1 (camera lens not covered, displaying an image) |
| *c | Waveform 2 (camera lens covered, blacking out the screen) |
| *d | Synchronization Signal |
| *e | Video Waveform |
|
| ||||
| OK | ||
| ||