REAR COMBINATION LIGHT ASSEMBLY > ON-VEHICLE INSPECTION |
| 1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH |
![]() |
Disconnect the T8 and T16 rear combination light assembly LH connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T8-1 (B) - T8-2 (E) | Turn signal switch in neutral position | Below 1 V |
| Turn signal switch in left turn position | 11 to 14 V (60 to 120 times per minute) | |
| T16-2 (TL) - T9-3 (E) | Light control switch off | Below 1 V |
| Light control switch in tail position | 11 to 14 V | |
| T16-1 (B) - T9-3 (E) | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V |
| *a | Front view of wire harness connector (to Rear Combination Light Assembly LH) |
| 2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH |
![]() |
Disconnect the T13 and T17 rear combination light assembly RH connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T13-1 (B) - T13-2 (E) | Turn signal switch in neutral position | Below 1 V |
| Turn signal switch in right turn position | 11 to 14 V (60 to 120 times per minute) | |
| T17-2 (TL) - T17-3 (E) | Light control switch off | Below 1 V |
| Light control switch in tail position | 11 to 14 V | |
| T17-1 (B) - T17-3 (E) | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V |
| *a | Front view of wire harness connector (to Rear Combination Light Assembly RH) |