Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR LIGHT ASSEMBLY LH


    E220290E01
  1. Disconnect the connector from the rear light assembly LH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T7-1 (B) - T7-3 (E)
    Engine started and the shift lever not in R
    Below 1 V
    Engine started and the shift lever in R
    11 to 14 V
    T7-2 (B) - T7-3 (E)
    Light control switch off
    Below 1 V
    Light control switch in tail position
    11 to 14 V
    T7-4 (B)*1 - T7-3 (E)
    Light control switch in tail position, rear fog light switch off
    Below 1 V
    Light control switch in tail position, rear fog light switch on
    11 to 14 V

    *1: w/ Rear Fog Light
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly LH)
    If the result is not as specified, repair or replace the wire harness or connector.



2. INSPECT REAR LIGHT ASSEMBLY RH


    E220290E02
  1. Disconnect the connector from the rear light assembly RH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T1-1 (B) - T1-3 (E)
    Engine started and the shift lever not in R
    Below 1 V
    Engine started and the shift lever in R
    11 to 14 V
    T1-2 (B) - T1-3 (E)
    Light control switch off
    Below 1 V
    Light control switch in tail position
    11 to 14 V
    T1-4 (B)*1 - T1-3 (E)
    Light control switch in tail position, rear fog light switch off
    Below 1 V
    Light control switch in tail position, rear fog light switch on
    11 to 14 V

    *1: w/ Rear Fog Light
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly RH)
    If the result is not as specified, repair or replace the wire harness or connector.