Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT SWITCH

VANITY LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT VISOR ASSEMBLY LH


  1. Inspect the vanity light switch.



      E224621E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Visor up
      10 kΩ or higher
      1 - 2
      Mirror cover fully closed with visor down
      10 kΩ or higher
      1 - 2
      Mirror cover fully open with visor down
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Visor Assembly LH)
      *b
      Visor up
      *c
      Visor down
      *1
      Mirror Cover
      If the result is not as specified, replace the visor assembly LH.



2. INSPECT VISOR ASSEMBLY RH


  1. Inspect the vanity light switch.



      E224622E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Visor up
      10 kΩ or higher
      1 - 2
      Mirror cover fully closed with visor down
      10 kΩ or higher
      1 - 2
      Mirror cover fully open with visor down
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Visor Assembly RH)
      *b
      Visor up
      *c
      Visor down
      *1
      Mirror Cover
      If the result is not as specified, replace the visor assembly RH.