AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR CONDITIONING PRESSURE SENSOR |
Check the wire harness.
Disconnect the A55 air conditioning pressure sensor connector.
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-1 (-) - I77-13 (SG-2) | Always | Below 1 Ω |
| A55-2 (PR) - I77-9 (PRE) | Always | Below 1 Ω |
| A55-3 (+) - I77-10 (S5-3) | Always | Below 1 Ω |
| A55-1 (-) - Body ground | Always | 10 kΩ or higher |
| A55-2 (PR) - Body ground | Always | 10 kΩ or higher |
| A55-3 (+) - Body ground | Always | 10 kΩ or higher |
Reconnect the I77 air conditioning amplifier assembly connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch condition | Specified Condition |
| A55-3 (+) - Body ground | Power switch on (IG) | 4.75 to 5.25 V |
Check the air conditioning pressure sensor.
Install a manifold gauge set.
Connect the connector to the air conditioning pressure sensor.
Turn the power switch on (READY).
Turn the A/C switch on.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I77-9 (PRE) - I77-13 (SG-2) | Refrigerant pressure: (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi)) | 0.50 to 4.80 V |
| *a | Component with harness connected (Air Conditioning Amplifier) |