Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Disc cannot be Inserted or is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IF A PROPER DISC IS INSERTED
  1. Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    Disc is normal.

    HINT:
    1. Translucent or uniquely-shaped CDs cannot be played.
    2. CDs with adhesive paper labels should not be played.
    3. Commercial audio CDs can be played.
    4. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
    6. For details on playable CDs, refer to the Owner's Manual.



NG
CHANGE DISC
OK


2.CHECK THAT DISC IS INSERTED PROPERLY
  1. Check if the disc is inserted upside down.

    OK:
    Disc is properly inserted.



NG
INSERT DISC PROPERLY
OK


3.CLEAN DISC AND RECHECK


    I100151
  1. Clean disc by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 4
OK

END (DISC WAS DIRTY) 

4.REPLACE DISC AND RECHECK
  1. Replace the disc with a known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END (DISC WAS FAULTY)