Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM


E268447E23


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the H155 radio and display receiver assembly connector.

  1. Disconnect the H187 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H155-13 (VV+) - H187-6 (VV+)
    Always
    Below 1 Ω
    H155-14 (VV-) - H187-11 (VV-)
    Always
    Below 1 Ω
    H155-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    H155-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    H155-12 (SG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)