Home › Engine / Hybrid System › 2AR-FXE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING CHAIN COVER OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.

    NOTICE:
    1. Do not allow foreign matter to contact the lip of the oil seal.
    2. Do not allow MP grease to contact the dust seal.



    A195808E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

    SST
    09223-22010  

    NOTICE:
    1. Keep the lip of the oil seal free from foreign matter.
    2. Do not tap in the oil seal at an angle.



2. INSTALL CRANKSHAFT PULLEY
  1. Align the pulley set key with the key groove of the crankshaft pulley.



    A264825E03
  1. Using SST, hold the crankshaft pulley and install the pulley bolt.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-54015  
    09330-00021  

    Torque:
    260 N*m{ 2651 kgf*cm , 192 ft.*lbf }

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



3. INSPECT FOR OIL LEAK


4. INSTALL FRONT FENDER APRON SEAL RH


5. INSTALL ENGINE UNDER COVER RH


6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH


7. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }