Home › Engine / Hybrid System › 2AR-FXE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


3. REMOVE ENGINE UNDER COVER RH


4. REMOVE FRONT FENDER APRON SEAL RH


5. REMOVE CRANKSHAFT PULLEY


    A264823E03
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-54015  
    09330-00021  

    HINT:
    SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650 (2 pcs)



    A210637E02
  1. Using SST and the pulley bolt, remove the crankshaft pulley.
    Text in Illustration 
    *1
    Pulley Bolt
    *a
    Hold
    *b
    Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)

    HINT:
    Apply a lubricant to the threads and end of SST.



6. REMOVE TIMING CHAIN COVER OIL SEAL


    A195807
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or the crankshaft.