Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FRAME WIRE

FRAME WIRE > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
(Click here)


3. REMOVE FUEL TANK ASSEMBLY
(Click here)


4. SEPARATE REAR SEATBACK ASSEMBLY RH
  1. Fold down the rear seatback assembly RH.



5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide RH.



    B284999
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



6. REMOVE ROOM PARTITION BOARD LH


    B285001
  1. Using a clip remover, remove the clip.

  1. Disengage the 5 claws and clip, and remove the room partition board LH.



7. REMOVE NO. 2 FRONT FLOOR FOOTREST COVER RH


    A259993
  1. Remove the 6 clips and No. 2 front floor footrest cover RH.



8. REMOVE NO. 4 HYBRID BATTERY SHIELD PANEL

CAUTION:
Wear insulated gloves.



    A259416E01
  1. Using the service plug grip, remove the battery cover lock striker.
    Text in Illustration 
    *1
    Service Plug Grip
    *2
    Battery Cover Lock Striker
    *3
    Button
    *a
    Projection
    *b
    Turn

    HINT:
    Insert the projecting part of the service plug grip, and turn the button of the battery cover lock striker counterclockwise to release the lock.



    A259419
  1. Remove the bolt, 2 nuts and No. 4 hybrid battery shield panel.



9. REMOVE NO. 4 FLOOR WIRE

CAUTION:
Wear insulated gloves.

NOTICE:
Insulate the removed terminals with insulating tape.



    A259420
  1. Disconnect the 2 connectors.

  1. Disconnect the shielded wire ground.



    A259991
  1. Disconnect the wire harness clamp and connector.



    A259992
  1. Disengage the 3 claws and push the frame wire out from the floor panel.



    A259985
  1. Disconnect the 2 wire harness clamps.



    A256829E01
  1. Disconnect the 2 wire harness clamps and connector.
    Text in Illustration 
    *A
    for LHD:
    *B
    for RHD:

  1. Remove the 2 nuts.



    A259990
  1. Remove the bolt and disconnect the clamp.



    A259989
  1. Remove the 2 bolts.



  1. Remove the 4 nuts.


    A259987



  1. Disconnect the 2 clamps and remove the No. 4 floor wire.


    A259988

    HINT:
    When removing the clamp, break the claw on the clamp. The clamp cannot be reused.