Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT (w/ Filter)

BATTERY COOLING DUCT (w/ Filter) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER


    A318968
  1. Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

    NOTICE:
    A308345E01
    Make sure the rubber portion of the No. 1 hybrid battery intake filter is behind the points shown in the illustration.
    Text in Illustration 
    *a
    Cross Section View of No. 1 Hybrid Battery Intake Duct
    *b
    Rubber Portion of No. 1 Hybrid Battery Intake Filter



    A318969E02
  1. Apply 3 pieces of tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.
    Text in Illustration 
    *a
    Tape

    HINT:
    If the adhesion of the tape is weak, replace it with new tape.



2. INSTALL REAR SIDE SEATBACK ASSEMBLY LH
  1. Place the rear side seatback assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Engage the hook to install the rear side seatback assembly LH with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the rear seat outer belt to the rear seat shoulder belt guide LH.



3. INSTALL REAR SEATBACK ASSEMBLY
  1. Lift the rear seatback assembly LH.



    B284996
  1. Engage the guide and claw to install the No. 2 room partition cover.

  1. Connect the rear seat outer belt to the rear seat center shoulder belt guide.

  1. Lift the rear seatback assembly RH.



4. INSTALL REAR SEAT CUSHION LOCK HOOK


    B280246
  1. Engage the claw to install a new rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



5. INSTALL REAR SEAT CUSHION ASSEMBLY
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B298857
  1. Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is firmly installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.



6. CLEAR DTC

HINT:
If the message "Cooling performance of the hybrid battery is low Consult a dealer" is displayed on the multi-information display, clean or replace the No. 1 hybrid battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output (Click here).