Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > INSTALLATION

for Preparation Click here



1. INSTALL BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
  1. Be sure not to touch the fan part of the battery cooling blower assembly.
  2. Do not lift the battery cooling blower assembly using the wire harness.

  1. Install the battery cooling blower assembly with the 3 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL NO. 2 HYBRID BATTERY INTAKE DUCT
  1. Engage the 2 claws to install the No. 2 hybrid battery intake duct.

    NOTICE:
    Ensure that the duct is installed securely.

  1. Install the clip.



3. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT
  1. Install the No. 1 hybrid battery intake duct with the 3 clips.

    NOTICE:
    Ensure that the duct is installed securely.



4. INSTALL REAR SIDE SEATBACK ASSEMBLY LH
  1. Place the rear side seatback assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Engage the hook to install the rear side seatback assembly LH with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the rear seat outer belt to the rear seat shoulder belt guide LH.



5. INSTALL REAR SEATBACK ASSEMBLY
  1. Lift the rear seatback assembly LH.



    B284996
  1. Engage the guide and claw to install the No. 2 room partition cover.

  1. Connect the rear seat outer belt to the rear seat center shoulder belt guide.

  1. Lift the rear seatback assembly RH.



6. INSTALL REAR SEAT CUSHION LOCK HOOK


    B280246
  1. Engage the claw to install a new rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



7. INSTALL REAR SEAT CUSHION ASSEMBLY
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B298857
  1. Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is firmly installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.



8. INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER
  1. Engage the 2 claws.

  1. Engage the 8 fasteners and install the luggage compartment front trim cover.



9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



10. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.