Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > REMOVAL

for Preparation Click here



1. REMOVE BAGGAGE HOLDER NET (w/ Partition Net)
  1. Remove the baggage holder net.



2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
  1. Remove the luggage compartment floor mat.



3. REMOVE LUGGAGE COMPARTMENT FRONT TRIM COVER


    B287041
  1. Disengage the 8 fasteners.

  1. Disengage the 2 claws and remove the luggage compartment front trim cover.



4. REMOVE REAR SEAT CUSHION ASSEMBLY


    B298856E01
  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



5. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the LH side and RH side.



6. SEPARATE REAR SEATBACK ASSEMBLY
  1. Fold down the rear seatback assembly RH.

  1. Disconnect the rear seat outer belt from the rear seat center shoulder belt guide.



    B284995
  1. Using a moulding remover, disengage the claw and guide, and remove the No. 2 room partition cover.



    B284997
  1. Pull the cable in the direction shown in the illustration to release the rear seatback lock and then fold the rear seatback assembly LH forward.



7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide LH.



    B285000
  1. Remove the bolt.

  1. Disengage the hook and remove the rear side seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT


    A259450
  1. Remove the 3 clips and No. 1 hybrid battery intake duct.



9. REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT


    A259427
  1. Remove the clip.

  1. Disengage the 2 claws and remove the No. 2 hybrid battery intake duct.



10. REMOVE BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
  1. Be sure not to touch the fan part of the battery cooling blower assembly.
  2. Do not lift the battery cooling blower assembly using the wire harness.



    A259428
  1. Disconnect the connector from the battery cooling blower assembly.

  1. Remove the 3 nuts and battery cooling blower assembly.