BATTERY COOLING DUCT (w/ Filter) > REMOVAL |
| 1. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 2. REMOVE REAR SEAT CUSHION LOCK HOOK |
![]() |
Disengage the claw and remove the rear seat cushion lock hook.
| 3. SEPARATE REAR SEATBACK ASSEMBLY |
Fold down the rear seatback assembly RH.
Disconnect the rear seat outer belt from the rear seat center shoulder belt guide.
![]() |
Using a moulding remover, disengage the claw and guide, and remove the No. 2 room partition cover.
![]() |
Pull the cable in the direction shown in the illustration to release the rear seatback lock and then fold the rear seatback assembly LH forward.
| 4. REMOVE REAR SIDE SEATBACK ASSEMBLY LH |
Disconnect the rear seat outer belt from the rear seat shoulder belt guide LH.
![]() |
Remove the bolt.
Disengage the hook and remove the rear side seatback assembly LH.
| 5. REMOVE NO. 1 HYBRID BATTERY INTAKE FILTER |
![]() |
Remove the 3 pieces of tape shown in the illustration and remove the No. 1 hybrid battery intake filter from the No. 1 hybrid battery intake duct.
| *a | Tape |