THEFT DETERRENT SYSTEM > SYSTEM DESCRIPTION |
| OUTLINE OF THEFT DETERRENT SYSTEM |
Disarmed state:
Arming preparation state:
Armed state:
Alarm sounding state:
| Alarm Method | Hazard Warning Lights | Blinking |
| Vehicle Horns | Sounding (approx. 0.4-second cycles) | |
| Security Horn | Sounding (approx. 0.4-second cycles) | |
| Alarm Time | Approx. 27.5 seconds | |
| FUNCTION OF MAIN COMPONENTS |
| Component | Function |
| Security indicator light | Informs driver of theft deterrent system status. |
| Security horn | Sounds when attempted break-in or theft is detected. |
| Hazard warning lights | Blink when attempted break-in or theft is detected. |
| Vehicle horns | Sound when attempted break-in or theft is detected. |
| Door courtesy light switch | Detects door status (open or closed). |
| Door unlock detection switch | Detects door status (locked or unlocked). |
| Engine hood courtesy switch | Detects engine hood status (open or closed). |
| Luggage compartment door courtesy light switch | Detects luggage compartment door status (open or closed). |
| Certification ECU (smart key ECU assembly) |
|
| ACTIVE ARMING MODE |
Active arming mode:
This system operates as described in the diagram below when one of the items for each condition is met.

| Condition | Item |
| Condition [1] | In disarmed state 1, when the power switch is off, the system state is switched if the following condition is met:
|
| Condition [2] |
|
| Condition [3] |
|
| Condition [4] |
|
| Condition [5] |
|
| Condition [6] |
|
| Condition [7] |
|
| Condition [8] |
|
| Condition [9] |
|
| Condition [10] | In disarmed state 1, when the power switch is off, the system state is switched if the following condition is met:
|
| Condition [11] |
|
| FORCED DOOR LOCK CONTROL |
The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (armed starts), all doors are forced to lock by a forced door lock signal.
If the following conditions are met, the forced door lock control is operated.
| SECURITY INDICATOR LIGHT OUTPUT |
According to the state of the theft deterrent system the main body ECU (multiplex network body ECU) outputs a signal to turn the security indicator light on. However, some of the actual lighting conditions of the security indicator light are different from the output signals of the main body ECU (multiplex network body ECU).
| State of Theft Deterrent System | Security Indicator Light | |
| Output Signal from Main Body ECU (Multiplex Network Body ECU) | Actual Lighting Condition | |
| Disarmed state (1), (2) | OFF | OFF (Engine immobiliser system unset) BLINKING (Engine immobiliser system set) |
| Arming preparation state | ON | ON |
| Armed state | OFF | BLINKING |
| Alarm sounding state | ON | ON |
| Time | Security Indicator Light |
| 0.125 sec. | ON |
| 1.875 sec. | OFF |