Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

Power Steering System 
DTC No.
Detection Condition
Fail-safe
C1511/11
Torque sensor malfunction
Assist force restricted or power assist stopped
C1512/11
C1513/11
C1514/11
C1521/25
Motor circuit malfunction
C1524/24
C1528/12
Motor rotation angle sensor malfunction
C1531/25
ECU malfunction
C1532/25
C1533/25
C1534/25
C1541/13
Vehicle speed signal malfunction
Assist force restricted
C1551/25
IG power source voltage error
Power assist stopped
C1552/22
PIG power source voltage error
C1554/23
Power source relay malfunction
C1555/25
Motor relay malfunction
C1581/26
Assist map not written in power steering ECU assembly
Controlled using default map
C1582/26
Assist map mismatch written in power steering ECU assembly
Controlled using current default map
U0129/42
Lost communication with brake booster with master cylinder assembly
Assist force restricted
U0293/41
HV ECU communication error
Power assist stopped

HINT:
  1. The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the power switch on (READY).
  2. If the auxiliary battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns to normal when the auxiliary battery voltage recovers.