Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. Read the Data List according to the display on the intelligent tester.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Power switch ACC signal/ON or OFF
    ON: Power switch on (ACC)
    OFF: Power switch off
    -
    IG SW
    Power switch IG signal/ON or OFF
    ON: Power switch on (IG)
    OFF: Power switch off
    -
    RR Door Courtesy SW
    Rear door courtesy light switch RH signal/ON or OFF
    ON: Rear door RH open
    OFF: Rear door RH closed
    -
    RL Door Courtesy SW
    Rear door courtesy light switch LH signal/ON or OFF
    ON: Rear door LH open
    OFF: Rear door LH closed
    -
    FR Door Lock Pos
    Front door RH unlock detection switch signal/LOCK or UNLOCK
    LOCK: Front door RH locked
    UNLOCK: Front door RH unlocked
    -
    FR Door Courtesy
    Front door courtesy light switch RH signal/ON or OFF
    ON: Front door RH closed
    OFF: Front door RH open
    -
    FL Door Lock Pos
    Front door LH unlock detection switch signal/LOCK or UNLOCK
    LOCK: Front door LH locked
    UNLOCK: Front door LH unlocked
    -
    FL Door Courtesy
    Front door courtesy light switch LH signal/ON or OFF
    ON: Front door LH closed
    OFF: Front door LH open
    -
    RR-Door Lock Pos SW
    Rear door RH and LH unlock detection switch signal/ON or OFF
    ON: Rear door RH or LH unlocked
    OFF: Rear door RH and LH locked
    -
    RL-Door Lock Pos SW
    Rear door RH and LH unlock detection switch signal/ON or OFF
    ON: Rear door RH or LH unlocked
    OFF: Rear door RH and LH locked
    -
    Wireless Control
    Wireless door lock control function/ON or OFF
    Customization status displayed
    -
    Hazard Answer Back
    Hazard answer-back of wireless/ON or OFF
    Customization status displayed
    -
    Open Door Warning
    Open door warning/ON or OFF
    Customization status displayed
    -
    Unlock 2 Operation
    2 times operation of wireless unlock/ON or OFF
    Customization status displayed
    -
    Auto Lock Time
    Automatic lock time/120 s, 60 s or 30 s
    Customization status displayed
    -
    Wireless Buzzer Resp
    Buzzer answer-back of wireless/ON or OFF
    Customization status displayed
    -
    P/W Wireless Ope Buzz
    Buzzer sounds of wireless power window/ON or OFF
    Customization status displayed
    -
    Wireless Buzzer Vol
    Wireless door lock buzzer volume/Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0
    Customization status displayed
    -
    Trunk Lid Operation
    Opening the luggage compartment door by the electrical key transmitter sub-assembly/1 tim ON, 2 tim ON, Long1, Long2 or Prohibit
    Customization status displayed
    -


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Active Test.

  5. Perform the Active Test according to the display on the intelligent tester.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Interior lights (Interior light switch is in door position and all doors are closed)
    OFF/ON
    -
    Door Lock
    Door lock motor
    Unlock/Lock
    -
    Trunk and Back-Door Open
    Luggage door lock motor
    OFF/ON
    -
    Wireless Buzzer
    Wireless door lock buzzer
    OFF/ON
    -